This Article Full Text (PDF) References Alert me when this article is cited Alert me if a correction is posted Citation Map Services Email this article to a friend Similar articles in this journal Similar articles in ISI Web of Science Alert me to new issues of the journal Add to Saved Citations Download to citation manager Request Permissions Request Reprints Add to My Marked Citations Citing Articles Citing Articles via ISI Web of Science (9) Citing Articles via Google Scholar Citing Articles via Scopus Google Scholar Articles by Veneman, J. F. Articles by van der Kooij, H. Search for Related Content Social Bookmarking                   What's this?

A Series Elastic- and Bowden-Cable-Based Actuation System for Use as Torque Actuator in Exoskeleton-Type Robots

R. Ekkelenkamp

R. Kruidhof

F. C.T. van der Helm

Biomechanical Engineering, BMTI University of Twente P.O. Box 217, 7500 AE Enschede The Netherlands

H. van der Kooij

Biomechanical Engineering, BMTI University of Twente P.O. Box 217, 7500 AE Enschede The Netherlands H.vanderKooij{at}utwente.nl

Within the context of impedance controlled exoskeletons, common actuators have important drawbacks. Either the actuators are heavy, have a complex structure or are poor torque sources, due to gearing or heavy nonlinearity. Considering our application, an impedance controlled gait rehabilitation robot for treadmill-training, we designed an actuation system that might avoid these drawbacks. It combines a lightweight joint and a simple structure with adequate torque source quality. It consists of a servomotor, a flexible Bowden cable transmission, and a force feedback loop based on a series elastic element. A basic model was developed that is shown to describe the basic dynamics of the actuator well enough for design purpose.

Further measurements show that performance is sufficient for use in a gait rehabilitation robot. The demanded force tracking bandwidths were met: 11 Hz bandwidth for the full force range (demanded 4 Hz) and 20 Hz bandwidth for smaller force range (demanded 12 Hz). The mechanical output impedance of the actuator could be reduced to hardly perceptible level. Maxima of about 0.7 Nm peaks for 4 Hz imposed motions appeared, corresponding to less than 2.5% of the maximal force output. These peaks were caused by the stick friction in the Bowden cables.

Spring stiffness variation showed that both a too stiff and a too compliant spring can worsen performance. A stiff spring reduces the maximum allowable controller gain. The relatively low control gain then causes a larger effect of stick in the force output, resulting in a less smooth output in general. Low spring stiffness, on the other side, decreases the performance of the system, because saturation will occur sooner.

Key Words: actuator design • cable transmission • exoskeleton • impedance control • rehabilitation robotics

The International Journal of Robotics Research, Vol. 25, No. 3, 261-281 (2006)
DOI: 10.1177/0278364906063829


CiteULike    Connotea    Del.icio.us    Digg    Reddit    Technorati    What's this?